TCRC 2PCS High Steering Angle Universal Grade 5 Titanium U-Joint Axle Shafts +4MM Wide CVD for Axial SCX24 AX24

These axles were great to give me more steering angle for my SCX24. They fit fine, but they give you a wider +4mm track width, so you'll need to be aware of that if you're going for a specific look or need specific clearances. The quality seems to be pretty strong and good, and they work great giving you that increased steering angle capability. Overall it's definitely a worthwhile upgrade if you're looking for more steering angle and don't mind the wider axle width.

I ordered these stainless axle shafts to replace the factory shafts in my SCX24. I used them in my factory axle.The shafts seem well made. The parts didn’t have any burrs and the fit was tight where the knuckle bearings interface. The u-joint seems to work well though I didn’t get any additional steering angle out of these shafts (I think it’s limited by my stock servo horn).The +4mm of width definitely looks cool. I’m hoping the slightly wider stance adds some stability as well. I think my tires rub a little more than before but not badly enough to cause an issue.These shafts do add some weight but it’s negligible compared to the brass knuckles I installed at the same time.I’m giving these 4 stars because they should come with a spacer of some sort to hold the outer bearing in place when used with factory axles & knuckles.Overall a cool upgrade but probably not worth it unless you have other supporting mods.

The media could not be loaded.

Great angle without binding. Super strong and they pop right in.

The media could not be loaded.

I put these in after upgrading to brass knuckles. The knuckles came with some sealed bearings that to be honest were a little sloppy on the stock driveshafts, but fit perfectly on these universals. It cautions you may have to leave out one of the bearings, but I didn't.I also modified my the c-hubs and now have a really good turning radius. Smooth as silk right off. Highly recommended!